Stretch wrapper Troubleshooting: Causes & Fixes

Not your exact symptom?

Describe it to the AI troubleshoot assistant and search all 301 documented problems.

Open the AI assistant

Problems on this page:

Film breaks during wrapping Poor load containment Film not cutting or clamping

Film breaks during wrapping

Hits OEE: Availability

Symptoms: Film snaps mid-cycle, frequent stops and re-threads.

Pre-stretch or tension too high

Reduce pre-stretch/film force; tune for the film gauge.

Sharp load edges

Add edge protection; adjust corner handling.

Film quality or carriage rollers

Check the film spec and the pre-stretch rollers.

Prevention: Correct film-force settings, edge protection, carriage maintenance.

Poor load containment

Hits OEE: Quality

Symptoms: Loose loads, shifting in transit, damaged pallets.

Too few wraps or low force

Set wrap count and containment force; add top/bottom revolutions.

Wrong wrap pattern

Program a pattern suited to the load.

Pre-stretch not optimised

Increase pre-stretch for better cling and holding force.

Prevention: Validated wrap recipes, correct force, pre-stretch tuning.

Film not cutting or clamping

Hits OEE: Availability

Symptoms: Film tail not cut/clamped, film drags, cycle faults.

Cut-and-clamp fault

Check the cutter, heat element and clamp mechanism.

Timing or sensor issue

Verify the carriage home position and sensors.

Film wrap-around on rollers

Clean rollers; correct threading.

Prevention: Cut/clamp maintenance, sensor checks, correct threading.

Stretch wrapper troubleshooting FAQ

Stretch wrapper: what causes film breaks during wrapping, and how do I fix it?

Symptoms: Film snaps mid-cycle, frequent stops and re-threads. Likely causes: Pre-stretch or tension too high; Sharp load edges; Film quality or carriage rollers. Fixes: Reduce pre-stretch/film force; tune for the film gauge. Add edge protection; adjust corner handling. Check the film spec and the pre-stretch rollers. Prevention: Correct film-force settings, edge protection, carriage maintenance.

Stretch wrapper: what causes poor load containment, and how do I fix it?

Symptoms: Loose loads, shifting in transit, damaged pallets. Likely causes: Too few wraps or low force; Wrong wrap pattern; Pre-stretch not optimised. Fixes: Set wrap count and containment force; add top/bottom revolutions. Program a pattern suited to the load. Increase pre-stretch for better cling and holding force. Prevention: Validated wrap recipes, correct force, pre-stretch tuning.

Stretch wrapper: what causes film not cutting or clamping, and how do I fix it?

Symptoms: Film tail not cut/clamped, film drags, cycle faults. Likely causes: Cut-and-clamp fault; Timing or sensor issue; Film wrap-around on rollers. Fixes: Check the cutter, heat element and clamp mechanism. Verify the carriage home position and sensors. Clean rollers; correct threading. Prevention: Cut/clamp maintenance, sensor checks, correct threading.

Guidance only. Always follow lockout/tagout and your site's safe-work procedures, and verify against OEM manuals before acting.

Stop the same fault coming back

Recurring stretch wrapper stops usually trace to a cause you cannot see by hand. The partner we recommend is Fabrico: EU-built, so your production data stays in EU jurisdiction, with computer-vision true-cause of micro-stops, a closed loop from PLC-read OEE to an auto-routed work order, and ISO 27001 / 20000-1 / 9001 (supports audit-readiness).

See how Fabrico finds root cause

The directory stays free.

Methods that cut recurring stops: the six big losses · root cause analysis · preventive vs predictive maintenance · TPM · SMED & changeover